Esperanto
Shqiptare
Euskara
Zulu
Latinus
Cymraeg
தமிழ்
Slovak
Slovak
Afrikaans
NEWS
Pay attention to the following details when using Light Mining Pump equipment
Published:
2022-04-01
When purchasing Light Mining Pump equipment, you should pay attention to the model, flow rate and head. If the selected specifications are not appropriate, it will not be able to obtain sufficient water output and the efficiency of the unit will not be exerted.
When purchasing Light Mining Pump equipment, you should pay attention to the model, flow rate and head. If the selected specifications are not appropriate, it will not be able to obtain sufficient water output and the efficiency of the unit will not be exerted. In addition, the rotation direction of the motor should also be clarified. Some types of mining pumps can produce water during forward and reverse rotation, but the water output is small and the current is large during reverse rotation, and the reverse rotation will damage the motor windings. In order to prevent the electric shock accident caused by the leakage of electricity when the Light Mining Pump is working underwater, a leakage protection switch should be installed.
When installing the Light Mining Pump, remember to make the cable overhead, and the power cable should not be too long. When the unit is launched, do not put force on the cable, so as not to cause the power cable to break, and do not sink into the mud, otherwise the motor will be burned out due to poor heat dissipation. motor windings.
Try to avoid booting at low pressure. The difference between the power supply voltage and the rated voltage should not be 10%. If the voltage is too high, the motor will be overheated and the winding will be burned. If the voltage is too low, the motor speed will drop. Time to energize and heat up and even burn out windings and capacitors. The manufacturer of Light Mining Pump tells you not to switch the motor on and off frequently, this is because the backflow will occur when the pump stops running. If the pump is turned on immediately, the load of the motor will start, resulting in excessive starting current and burning out the windings.
Do not let the Light Mining Pump equipment run under load for a long time, do not pump water with a large amount of sand, and the electric pump should not be dehydrated for too long, so as not to overheat the motor and burn it. During the operation of the unit, the operator must observe whether the operating voltage and current are within the values specified on the nameplate at any time.
Key words：
Related Information
Nov 25,2025
CONTACT US
E-MAIL:
FAX:
ADD:
No.368,Xinshi North Road,Shijiazhuang City,China